I found a couple rubber spacers lying around and I use these to create some space between the bracket and the holes in my mower. You don’t have any existing holes in your mower, you could definitely find a spot to drill them. I put a pin through the existing holes in my mower. Once I found the final brackets that I wanted to use, I used washers as spacers to hold the bracket as tightly as possible while still allowing it to spin freely for the top portion. You’ll need to hold the end of the bolt while you tighten the one on the inside of the cap. I put the threaded end of the bolt through the end cap, and then put a lock washer on and a nut. The other end is smooth so that it will spin freely on the bracket. You can use 7/16 hex bolts because one of its end is threaded so that can be tightened down. Before I found the final brackets that I was going to use, I was testing it out with conduit. Step 2: Drill A Holeįrom there you’ll need to drill a hole in the center of your center cap so you can put the bolt through. Then measure this out on your PVC pipe and cut it to size. You’ll need to measure how much space you have between the back wheels of your mower. I started out with three inch PVC pipe and of course the proper end caps that go on to that as well. How To Make A Lawn Striper Step 1: Sizing The PVC Pipe Before I spend $200 on the Toro version, I decided to try a DIY build or preface this post by saying I’m certainly not an engineer, so if you have some ideas on things I could do to improve this, it’s kind of just a prototype right now to see if it would work for me, so go and leave those in the comments below if you have any ideas. I’m thinking about getting a striping kit for my Toro time master mower and although it strikes very well, just kind of curious about how much better it could be if I had a striping kit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |